This machine is produced according to international standards. The operation is simple, time-saving, the casting success rate is high, and the common tooth box can also be injection molded. The denture injection unit consists of a heater and a hot press. Heaters: temperature control, timers and electrical systems. Hot presses: frames, cylinders, heaters, brackets and flasks.Heating temperature: 282-288 ° C. Pressurization time: 7 minutes 30 seconds - 11 minutes. 1 The function of the heater is to heat the ink cartridge at a temperature of 282-288 ° C for about 7 minutes 30 seconds - 11 minutes to melt the flexible denture material in the ink cartridge. 2 The function of the hot press is to inject molten material into a previously prepared flask. 3 The heater will beep when it is heated. Please read the product manual carefully before operating the machine. Feedback is very important to us. It is impossible to address issues if we do not know about them! Faction is our ultimate goal. We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount. Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday. 7 minutes 30 seconds - 11 minutes. This item is in the category "Business & Industrial\Healthcare, Lab & Dental\Other Healthcare, Lab & Dental". The seller is "beautyluckwjl" and is located in this country: US. This item can be shipped to United States.