The Denture Injection System Is Easy to Operate, Has a Long Service Life, Low Maintenance Cost, High Success Rate, and Dental Laboratory Equipment for Denture Injection System, Which Is Very Necessary for Dentists. This Machine Is Produced According to International Standards. The Operation Is Simple, Time-saving, the Casting Success Rate Is High, and the Common Tooth Box Can Also Be Injection Molded. Flexible 400W Dental Denture Machine Dentistry Denture Injection Molding Machine. PRO Dental Lab Flexible Denture Injection Partial System Heater Machine CE&FDA.The Denture Injection Unit Consists of a Heater and a Hot Press. Heaters: Temperature Control, Timers and Electrical Systems. Hot Presses: Frames, Cylinders, Heaters, Brackets and Flasks.
7 Minutes 30 Seconds - 11 Minutes. 1 the Function of the Heater Is to Heat the Ink Cartridge at a Temperature of 282-288 ° C for About 7 Minutes 30 Seconds - 11 Minutes to Melt the Flexible Denture Material in the Ink Cartridge.2 the Function of the Hot Press Is to Inject Molten Material into a Previously Prepared Flask. 3 the Heater Will Beep When It Is Heated. Please Read the Product Manual Carefully Before Operating the Machine. Feedback is very important to us. It is impossible to address issues if we do not know about them! Faction is our ultimate goal. We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount. Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday. 7 minutes 30 seconds - 11 minutes.