UPS Dental Portable X Ray Mobile Film Imaging System Digital Machine Unit

This model combines the advantages of similar products found at home and abroad; it eliminates the shortcomings of the on-frequency X-ray machine (high current intensity and excess amounts of scrap x-rays). Using a Toshiba 0.3 micro-focus tube. The tube voltage frequency of this machine is 30 KHz. And the tube current is 1 MA. The radiation scope is at an angle of 24 degrees. Located within a distance of 1.2 meters ahead. This is an innovative Chinese design named the Green X-ray Machine.

Focal Spot To Skin Distance. Reference of the time of exposure. Operation of the Main Unit.

Make sure the fittings on the encasement list are packaged within the box. Install the blue ray tube to the foreside of the ball headthen tighten it.

Turn on the Powerthe pilot lamp will be light up. During this timethe digital tube will show the fore setting time. Now the equipment is in standby mode. Setting the time (Skip to next step if unneeded) Use the "SET""+"and" -" buttons to reset the time as follows: press SETthe pilot lamp above is illuminated the machine is now in the time setting mode? Then press "+" and" -" to set the time needed (time range is 1-9seconds); press set again when the time is adjusted the light lamp is off. The equipment is now in standby mode. Put the Tooth film plumb behind the tooth which is going to be taken picture and be as close as possible (the smooth side stick to the tooth).

Keep the ball head plumb to the tooth projection position; Have the ball headtooth and tooth film steadily mutually plumb. After positioninguse the ON/OFF on the main Unit to take pictures. (Notice: gently press 0.5 sec to turn it on). After exposure to the tubepress the start button again in case of an emergency to stop shooting and return to standby status.

(At this point there was no output rayso the dental films can be used again). Turn the power off when the work is finishedpress POWER making sure the pilot lamp is off. Don't keep the machine long in standby mode. Make sure the angle of filmtoothand ball head are properly aligned when taking a picture.

Keep them steady until the last step of picturing; making sure that there is no change in any of their positions. Remember to turn the power 0ff when work is done. Charge the battery if the machine cannot work and the red lamp lignt. After turning the power onwait one minute before taking picturesthis allows the ray to provide a steady output.

The equipment switches into protection mode automatically when the voltage is incorrect. If this occurs it will not be able to carry out the normal work of filming. When taking picturesthe ON/OFF button could stop the objection and then the machine goes back to the preparation mode. Use high quality tooth film and developing liquid to make clear pictures. Handle the ball head gently while in useso as not to damage the delicate component.

We usually set the time between 3-8 seconds when taking picturesbut the actual time of ray output is 0.2-0.5 seconds. Keep the tooth film and the liquid in a proper place and use them within the shelf-life period. Development of films should be performed at temperatures ranging between 23-25 degrees Celsius to ensure the image quality. Other requests accordance with the scope of the technical parameters.

Please read the manual carefully before using. This portable dental X-ray unit is high frequency machine. The body is small, light weight and nearly no radiation.

It has excellent image quality, portable storage, save more space. It uses high frequency and DC international power supply. All of the components installed in the central PC board concentrated. Shock, set-up, electron tubes, all of them are insulation vacuum, sealed stereotype protection.

There are also manual buttons installed on the surface of shell, as well as batteries and charges7. This unit mainly suitable for oral pre-treatment for learning internal organizational structure, root depth and so on, is indispensable in daily life clinic equipment, especially for dental implant surgery. It also can connect with sensor, is great convenience. The battery is durable, it can take about 5 hundred images after fully charged. It can be connected with intra-oral digital X-ray imaging system. Exposure time: 0.1--2.0s. Distance from skin to cone: 130mm. Tube focus: 0.3mm0.3mm. High-frequency design makes unit portable and compact, saving you space. Our 50/60Hz X-ray machine allows you to precisely control exposure time and repitition, providing consistent, customized images.

Simple internal structure makes for easy operation and maintenance. Delivers fast response speeds and high-accuracy output indexes. Adjustable KV (revolutions per minute of engine) and MA. Can be powered directly from regular DC outlet (Unlike other Large-scale 50/60Hz X-line machines, which usually require special electrical wiring). Features a Toshiba 0.3x0.3 micro-focus spherical kinescope, ensuring crystal-clear images.

Can be controlled from the mainframe. X 1 User Manual x 1. We understand the concerns and frustrations you might have, and will try our best to resolve the isuues. Or replace item for you free of charge. We strive to exceed all your expectations and put a smile on your face.

We stand behind our products and pride ourselves on OUTSTANDING customer service. The item "UPS Dental Portable X Ray Mobile Film Imaging System Digital Machine Unit" is in sale since Friday, June 12, 2020. This item is in the category "Business & Industrial\Healthcare, Lab & Dental\Medical & Lab Equipment, Devices\X-Ray Machines & Equipment\Other X-Ray Equipment". The seller is "dentalseiko" and is located in Fullerton, California.

This item can be shipped to United States.

Country/Region of Manufacture: China
MPN: GJ1170100500C
Brand: Unbranded
Intended Use/Discipline: Dentistry